How to season a cast iron pan

Seasoning is what gives cast iron its black, natural cooking surface. Here we go through what it is, when you need it, and how to do it, in the oven or on the stovetop.
Does a new Lursta pan need seasoning?
No. All Lursta cast iron is seasoned at the foundry in Lyrestad before it ships, with no PFAS or other synthetic coating. You can start cooking straight away. The surface then builds up a little more every time you use the pan.
What is seasoning?
When a thin layer of oil is heated enough, it bonds to the iron and forms a hard, black surface. This is called polymerisation. The surface protects against rust and helps food release. Several thin layers give a better surface than one thick one.
When do I need to season again?
- Food starts to stick.
- The surface looks grey, dull or patchy.
- Rust has appeared.
- The pan has been scrubbed hard or left to soak.

How to season a cast iron pan in the oven
- Wash and dry. Wash with hot water and dry with a towel. Then leave the pan on the hob for a while so every bit of moisture is gone.
- Wipe on a thin layer of oil. Use a neutral cooking oil. Cover the whole pan, including the outside and the handle.
- Wipe off the excess. Use a clean cloth or kitchen paper until the pan looks almost dry. Too much oil is the most common cause of a sticky surface.
- Upside down in the oven. Put the pan upside down in the oven at 250–275 °C, with a tray underneath to catch drips. It may smoke a little, so turn on the extractor fan.
- Leave it for an hour. Then turn off the oven and let the pan cool inside.
- Repeat if needed. Two or three rounds give a more even, harder-wearing surface.
Quicker: season on the stovetop
If it's just a small patch, or a surface that feels dry, the stovetop is enough. Heat the pan over medium heat, wipe on a drop of oil with kitchen paper and wipe it out so only a film is left. Leave the pan on the heat until it stops smoking, then let it cool.
Common problems
The surface is sticky
There was too much oil, or not enough heat. Put the pan back in the oven at the same temperature for an hour, without adding more oil.
Eggs and batter stick
Usually the pan isn't hot enough. Let the cast iron heat up over medium heat for a few minutes before anything goes in, and use butter or oil. Don't go straight to full heat. Cast iron needs time to heat evenly.
Rust has appeared
Scrub off the rust with steel wool, wash, dry thoroughly and season in the oven as above. Read more in Troubleshoot and restore.
How to keep the surface in shape
- Wash with hot water and a brush. A little washing-up liquid is fine.
- Dry straight away, ideally on the hob for a moment.
- Wipe on a thin layer of oil before you put it away.
- Cook in the pan often. That's the best maintenance there is.
More advice in the Cast Iron Guide. All our cast iron is under Cast Iron.


